The following information must be followed carefully to allow the vehicle to correctly learn the new sensor IDs:

Ensure all tyres are inflated to the pressure listed on the tyre placard.

Scan and gather all sensor information using a TPMS diagnostic tool.

Follow the instructions on the diagnostic tool and connect the OBDII module to the port on the vehicle.

Confirm the reset of the ECU with the diagnostic tool.

After a successful transfer, unplug the module and keep the ignition on.

Scan all four sensors using the diagnostic tool then drive over 30mph for 10 minutes

OBDII Port Location*

*The location shown is for left-hand drive vehicles.