The following information must be followed carefully to allow the vehicle to correctly learn the new sensor IDs:

Set the tyre pressure to the placard pressure

Read all sensor IDs

Park the car for 15 minutes

Drive until the new sensor ID's are learned by the ECU

Set tyre pressure

Read all sensor IDs

Turn ignition to ON (engine off) or by pushing rapidly twice on ON/START (With remote keyless entry)

Connect the OBDII Cable/Module to OBD connector

Follow the screen's instructions to reset the ECU

Turn ignition to OFF then ON (engine off)

Wait for 5 minutes

NOTICE: If the TPMS warning light remains ON, drive for 20 min

OBDII Port Location*

*The location shown is for left-hand drive vehicles.